For wires up to ø 0,7 mm. Ideal for labial arches and face bow.

Availabl in two sizes - for wire up to ø 0.5 mm and wire up to  ø 0.7 mm. Arch forming plier – Short. Ideal for torquing and bending squared or rectangular wire. Parallel blades prevents crushing of wires. Length 125 mm (0,5 mm wire) and 130 mm (0,7 mm wire).

For ligature wire with ø max 0,3 mm.

Flat beaks 130 mm. For wire up to ø max 0,8 mm.

For orthodontic pliers.

For orthodontic pliers.

One round and one quadrangular beak. For wire up to ø max: 0,7 mm.

For wir with ø max 0,7 mm.

The 2 sharpen tips allow to enter between the brackets base and tooth surface, lifting the bracket off, with virtually no stress.

For ligatures up to ø 0,3 mm.

For wire up to ø 1,0 mm.

For wire up to ø 0,7 mm.

For wire with ø max 1,0 mm.

Round tips prevents any damage of archwire. Instrument's length - 130 mm. Diameter of the prong - ø 2,0 mm.  

Plier for fast forming of lingual retainers on arches. For wire up to ø 0,7 mm. Length of the plier 120 mm.

Lightly rounded tips, for contouring and bending without damaging the archwire. Length - 130 mm.  

Loop bending plier. Four step tips (3, 4, 5, 6 mm) for loops forming. Round and rectangular wire. For wire up to ø max 0,7 mm. Legth - (mm 130).  

Pack of 2 pcs. replaceable tips for cap remover of reversible tubes.

Very sturdy, does not score wires. Suitable for bending the arms of expanders. For wires up to 1,5 mm.

Available in two diameters of the tips - 1,5 mm and 2,5 mm.

It cuts archwires and safely holds the loose distal end. Caution: maximum cutting capacity: - rectangular wire up to .022”x.028” (0,56x0,71 mm); - round wire up to .020” (0,51 mm); - twist wire up to .016” (0,41 mm).

The blades are designed to be parallel at .020” (0,51 mm) pliers opening. Working edges are carefully bevelled with a diamond hone to prevent wire scoring.

For wires up to 028" (0,71mm).

Plier for forming offsets in cuspid teeth.

Necessary for working round wires up to .032” (0,80 mm) in diameter. The beaks are .040” at the tip. A 9° angle is ground on the sides of pyramid beak to allow for wire springback. Beaks are parallel at .020” (0,51 mm) pliers opening.

The new instrument is simple, userfriendly, practical and economical. It allows the band to be adapted to tooth anatomy, without nicking or damaging it.